My final project was to create a maze in Inventor, and then use Fusion 360 prepare it to be created out of foam using the Router.
On Day 1, I completed most of the lower left of the maze.
On Day 2, I completed the branched out and completed the bottom half as well as completing most of the upper left. but I also realized I probably wouldn't be able to complete this project by the end of the school year, but I had already completed over half of my maze so I decided to just try and get as much done as I could.
On day 3, I completed the top left of my maze.
The picture above is the farthest I got in making the maze. and if I'm going to be honest, It doesn't feel complete. Because I see areas I could've used, but I didn't have the time
What I learned
I learned that you should think about how much time you have to do the work, and do your best effort you can depending on that time constraint, not do your absolute best and run out of time, and not get it done.